turn indicator

1. Carefully remove the handwheel and turn indicator sleeve assembly, leaving the valve at its balance set point.
   小心拆卸手轮，并旋转指示器套筒总成，将阀门保留在它的平衡设置点上。
2. Always turn off power, release pressure and remove a transmitter to non-hazardous area before disassembling and reassmbling an indicator.
   拆卸及重装表头时，关闭电源，释放压力，并将变送器移至安全区域。
3. With wrench, turn indicator to open position on indicator plate. Do not force past this point.
   用扳手将指示器旋转到指示器板上的开位置。不要用力超过这个点。
4. Start-up: After the lamp holder is connected with the power system, turn the main switch to ON and the flash indicator lamp ○ 6 will turn red.
   开机：灯头与电源机身连接好后，总开关向ON拨动，随后闪光灯机身指示灯⑥（红色）闪动。
5. A driver should signal his intention to turn by putting out his arm or by using his car indicator.
   汽车司机应伸出手臂或用汽车方向指示器表示想要转弯。
6. Loosen scale retaining ring and remove turn indicator assembly. It is not necessary to change the memory set point.
   松开刻度固定环，拆卸旋转指示器总成。不需要改变记忆设置点。
7. P: Turn& slip indicator ball stuck in center during turns.
   在转弯过程中，转弯侧滑仪小球保持在中间不动。
8. Every rate of turn indicator installation required to be provided shall comply with the performance standards adopted by the organization.
   规定须设置的每项回旋速度指示器装设，均须符合组织所采纳的性能标准。
9. If flow rate is in excess of that specified, turn indicator towards closed position, noting pressure drop and valve setting and determining new flow rates from flow rate chart.
   如果流量超过规定，将指示器旋转到关闭位置，注意压降和阀门设置，并从流量表中确定新的流量。
10. Plug in the power, turn on power switch, power indicator light then the light;
    插上电源，打开电源总开关，电源指示灯随即著亮；
11. Loosen the scale retaining ring and rotate the turn indicator scale to align with the "0" on the handwheel.
    松开刻度上的固定环，旋转指示器刻度使其对齐手轮上的“0”。
12. Following GPS waypoints, the vehicle is now rock-solid, to the point where you can turn your back on it. azimuth-stabilized plan position indicator
    车辆现在已经可以相当稳定地沿著GPS定位点行进，你可以转身不必理它了。方位稳定平面位置指示器
13. You can't turn left for example, coz the indicator stalk'll hit your knee.
    比如你不能左转，因为开关会碰到你的膝盖。
14. Remove handwheel and turn indicator sleeve by grasping the handwheel and pulling away from the valve body along the stem.
    拆卸手轮，并通过抓住手轮旋转指示器套筒，将其沿着阀杆从阀体内拉出。

noun

1. a blinking light on a motor vehicle that indicates the direction in which the vehicle is about to turn

   Synonym:    blinkerturn signaltrafficator